07 1月

Cisco CCNP 300-115 SWITCH Implementing Cisco IP Switched Networks試験問題集

Implementing Cisco IP Switched Networks(SWITCH 300-115)は、問題数 45 ~ 55 問、解答時間 120 分の試験です。Cisco CCNP Routing and Switching 認定および CCDP 認定を取得するには、300-115試験に合格する必要があります。SWITCH 300-115 は、スイッチングに関する知識とスキルを証明する試験です。300-115試験の合格者は、シスコのエンタープライズ キャンパス アーキテクチャを使用した複雑な企業向けスイッチング ソリューションの実装を計画し、設定し、検証する能力があると認定されます。 300-115 SWITCH 試験の内容には、VLAN と WLAN のセキュアな統合も含まれます。

ほかに、300-101 ROUTE試験300-135 TSHOOT試験を合格しなければなりません。CCNP認定で扱われるルーティング プロトコルおよびスイッチング プロトコルの知識やスキルは、今日の物理ネットワークにも将来の仮想的なネットワーク機能にも関連するものであり、今後長期にわたり職務能力の基盤となります。

以下は300-115 SWITCH試験の無料オンラインテストです。ご参考になってください。

What is the maximum number of switches that can be stacked using Cisco StackWise?

 
 
 
 
 
 

A network engineer wants to add a new switch to an existing switch stack.

Which configuration must be added to the new switch before it can be added to the switch stack?

 
 
 
 
 

What percentage of bandwidth is reduced when a stack cable is broken?

 
 
 
 
 

After an Ether Channel is configured between two Cisco switches, interface port channel 1 is in the down/down state. Switch A is configured with channel-group 1 mode active, while Switch B is configured with channel-group 1 mode desirable.

Why is the Ether Channel bundle not working?

 
 
 
 

An Ether Channel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the Ether Channel links is being utilized to reach the web server.

What should be done on the Cisco switch to allow for better Ether Channel utilization to the corporate web server?

 
 
 
 
 

Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs.

This command is configured globally:

monitor session 2 filter vlan 1 – 8, 39, 52

What is the result of the implemented command?

 
 
 
 
 

A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor relationships.

What would cause the output to show only the single neighbor?

 
 
 
 

After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco Discovery Protocol are not visible.

Which vendor-neutral protocol could be used to resolve this issue?

 
 
 
 

Several new switches have been added to the existing network as VTP clients. All of the new switches have been configured with the same VTP domain, password, and version. However, VLANs are not passing from the VTP server (existing network) to the VTP clients.

What must be done to fix this?

 
 
 
 

After implementing VTP, the extended VLANs are not being propagated to other VTP switches.

What should be configured for extended VLANs?

 
 
 
 

Question 1 of 10

 

buy

コメントを残す

メールアドレスが公開されることはありません。 * が付いている欄は必須項目です

*


ページ


最近の投稿


タグ

200-101 ICND2オンラインテスト 300-101 ROUTE オンラインテスト 300-115 SWITCH オンラインテスト 600-601 IMINS オンラインテスト 640-864J DESGN オンラインテスト Building Cisco Service Provider Next-Generation Networks CCIE Routing and Switching認定資格 CCIE Security written CCNA Interconnecting Cisco Networking Devices 1 (ICND1) 日本語版 CCNA Routing and Switching CCNP Collaboration認定資格 CCNP Routing and Switching認定資格 Cisco Cisco Architecture認定資格 Cisco CCDA認定資格 Cisco CCIE Data Center認定資格 Cisco CCIE認定資格 Cisco CCNA Data Center認定資格 Cisco CCNA SP認定資格 Cisco CCNA Voice認定資格 Cisco CCNA認定資格 Cisco CCNP Data Center認定資格 Cisco CCNP Security認定資格 Cisco CCNP Service Provider認定資格 Cisco CCNP SP Operations認定資格 Cisco CCNP Voice認定資格 Cisco CCNP Wireless認定資格 Cisco CCNP認定資格 Cisco IronPort認定資格 Cisco Others認定資格 Cisco Service Provider Mobility CDMA to LTE Specialist認定資格 Cisco Service Provider Mobility UMTS to LTE Specialist認定資格 Cisco Specialist認定資格 Implementing and Maintaining Cisco Technologies Using IOS XR Implementing Cisco Data Center Unified Fabric (DCUFI) Implementing Cisco IP Routing Implementing Cisco IP Switched Networks Implementing Cisco IP Telephony & Video Implementing Cisco Secure Access Solutions Implementing Cisco Secure Mobility Solutions Implementing Cisco TelePresence Video Networking Solutions Exam Implementing Cisco Threat Control Solutions (SITCS) Implementing Cisco Unified Communications Manager Managing Industrial Networks with Cisco Networking Technologies Part 1 v8.0 (CIPT1 v8.0)